The drilling and casing alternate – the drill string is taken out at specific intervals and the wellbore is lined with casing and cemented. We have some of the most advanced hole drilling capabilities and are continually developing new processes to drill holes as small as 1 micron. These tubes come in five standard sizes: 1/16”, 1/8”, 1/4”, 3/8”, and 1/2”. We help you pick the right tool for the job. Our Engineers will work closely with you to fully understand the requirements for your microholes (eg. SYNEO Accu-Drill and Accu-Punch equipment solutions are advanced, space-efficient solutions for drilling burr-free holes in a wide range of single and multi-lumen tubing materials such as Polyvinyl chloride (PVC), Low-density polyethylene (LDPE), PEEK, Polytetrafluoroethylene (PTFE) and Pebax®. Production with tubing. The Best Tools for Drilling Big Holes If you're remodeling, you might find yourself needing to bore some big holes through studs or joists. Custom micron hole sizes are also available upon request. Then drilling continues. Installing these metal band-aids is time-consuming, however, and drilling holes into tubing and pipe leaves hard-to-reach internal burrs and loose chips. Please Note: If you need a larger hole use the tool and a 1/8" drill bit; drill the hole all the way through your tubing then use a larger drill bit to enlarge your existing hole without the use of the tool. The heat is on As it turns out, there is. For your drilling or hole punch designs, please contact our team or call toll-free in the US 1-800-526-3842 or +1-803-268-9500 internationally today with your specification requirements based on the dimensions shown above. and recommend a process that will satisfy both your prototyping and production needs. 3. All of these tubes can have holes laser drilled in a range of diameters from 1µm to 1000µm. materials, part thickness, desired feature geometries, taper, etc.) Surely there must be a better way. I have 8ft length tubing that needs to have holes every 1ft on each side in order to install (Hex Rod Coupling Nuts) but … The Drill Steady is compatible with tubing measuring 1/2 inch–1-1/8 inch in diameter. Our unique capabilities range from custom punching and stamping for our Lay-Flat tubing to burr-free high speed drilling for thick-walled fluoropolymer tubing. Tubing transports the oil and gas from deep in the well to the surface – the third phase of the wellbore. I spend a lot of time drilling holes on square tubing or rectangle tubing with a drill press and my carbide hole saw and a lot of oil. Laser drilled tubing is used in many flow related fields.