ships rigging terminology

Aloft Above the deck, up the mast(s) or in the rigging.

No matter where you are, Nance & Underwood will always be here to assist you. nautical antiques?

The mast is supported by stays and shrouds that are known as the standing rigging because they are We can arrange the repair of your rigging hardware and sails here in our facility. Do you love sailing? This is a partial glossary of nautical terms; some remain current, while many date from the 17th to 19th centuries.See also Wiktionary's nautical terms, Category:Nautical terms, and Nautical metaphors in English.See the Further reading section for additional words and references. The Standing rigging refers to all the lines that support the stationary objects on a sailing yacht, such as the mast.

- Join over one thousand nautica lovers from across the globe an experience over a decade of experience collected together on a single site. If you do then this site was made for you! Nance & Underwood Rigging and Sails is your source for all of your rigging and sail equipment and services world wide. Getting to know all the components of a vessel might be a complicated task. These are generally steel cables and are called either ‘shrouds’ or ‘stays’.. For example, the line (cable) that runs from the mast to the bow of the boat is called the ‘forestay’, for lines that run to the stern of the boat are often called ‘backstays’. Tall Ships? Anchor Hold The hold of an anchor upon the ground.

We can ship rigging and sails gear anywhere. Rigging comprises the system of ropes, cables and chains, which support a sailing ship or sail boat's masts—standing rigging, including shrouds and stays—and which adjust the position of the vessel's sails and spars to which they are attached—the running rigging, … Hence that timber or frame, which has the greatest breadth and capacity in the ship is denominated the Midship Bend (q.v.). A shroud is a set of cables or ropes that keep the ship’s mast in its place. RIGGING – The ropes are wires that control the sails and support the masts are called “rigging.” RUDDER – When you turn the wheel on a vessel, it moves the “rudder” and allows you to steer. Technical Definition. However, Sailingyes is here to help you out through this introduction on the sailing ship shroud and rigging – two of the most important mechanisms of a watercraft. It’s usually a vertical plate or a board situated at the stern of the vessel. The basis of all rigging is the mast, which may be composed of one or many pieces of wood or metal.

Rigging, the sails, masts, booms, yards, stays, and lines of a sailing vessel, or its cordage only. Amidships In midships or in the middle of the ship, either with regard to her length or breadth.

Contact

 

LINE Contact